04-15-2011 11:39 AM
Hi,
We have a ASA 5540 and we would like to shutdown the VPN service. To do so, we would like to warn people by sending a message prompt when they logged in using Anyconnect. Message are only working on DA that terminate but not on those who Continue. I have also tried the Checkandmsg fonction but it behave the same way. The only discussion I found as been left unanswered:
https://supportforums.cisco.com/post!reply.jspa?message=892704#
Any Idea?
Best reagrds
Solved! Go to Solution.
04-16-2011 11:30 PM
Instead of using DAP to display messages, you should use Banner to display message.
Banner configuration can be performed via group-policy for the AnyConnect group:
Group Policy --> edit existing group policy --> General --> Banner text box.
Hope this helps.
04-16-2011 11:30 PM
Instead of using DAP to display messages, you should use Banner to display message.
Banner configuration can be performed via group-policy for the AnyConnect group:
Group Policy --> edit existing group policy --> General --> Banner text box.
Hope this helps.
04-19-2011 08:29 AM
Thank you. It's is exactely what I was looking for.
I have read documentation about banner and it says that Anyconnect only support partial HTLM. Did you know what it mean? I would like to insert a tag and it is not working. It would have been easier if they had a reference to wich HTML tag Anyconnect support.
Best Regards
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide