Ipsec-vpn using dynamic ip cable modem

[mariocabrejo]

Hi,

Is there a way to do a ipsec-vpn from either a router or pix using a cable broadband connection on the edge using dynamic ip. If so can you please write the link or some explanation.

Thanks

[drolemc]

If you are talking about a setup where one of the IPSec endpoints receives it's IP address dynamically, they yes, it is possible to setup an IPSec VPN between the two. You could refer to the configuration example at http://www.cisco.com/en/US/partner/tech/tk583/tk372/technologies_configuration_example09186a0080094a87.shtml