NAT on GetVPN

[avinashmahanty]

Hi,

I have a fully working GetVPN setup at work. We need to implement NAT on routers that fall in the path  (that is in path of the GetVPN GM servers). After struggling to make it work I found out in the Cisco Website "NAT is not supported in GETVPN". The document didn't specified any dates etc so wasn't sure if it was a limitation in the past and may have been addressed in future releases.

Has anyone implemented NAT in a GETVPN Solution? If yes, any tips on the NAT setup would be greatly appreciated.

Thx,

CT

[pjain2]

Hello,

" Network Address Translation (NAT) is not supported by GETVPN. NAT must be performed before encryption or after decryption when GET is used."

This is still not supported.

Regards