Where do I enter endpoint name in WRVS4400N for a dynamic IP?

[jfahlman1]

I have a Snapgear 560U VPN Gateway at the main office with VPN connections to several branch offices also using Snapgear 560U. Those are no longer manufactured though, so I bought a Cisco WRVS4400N for our new office. The main office has a fixed IP but the branch office ha a dynamic one. On the Snapgear's it is very clear where I need to enter the Mandatory endpoint name on the dynamic side of the tunnel, but I can't find anything on this on the Cisco WRVS4400N. So where do I enter this information so that I can make a VPN connection between the Snapgear & Cisco boxes?

Thanks in advance, Jason.

[Herbert Baerten]

Hi Jason,

since this question is about a product in the Cisco Small Business / Linksys range, I suggest you move it to the community, where you will have a better chance of getting expert advice.

best regards,

Herbert
Cisco Moderator