After upgrade to 9.1.1-074 I have problem with Report (by users, Web sites...)
It says "No data was found in the selected time range" but S170 is working normally.
In Alerts this message is:
Counter group "WEB_SERVICES_SUMMARY" does not exist.
An application fault occurred: There was an error opening the database. Reporting cannot continue.
Does anyone have a solution?
Thanks
Solved! Go to Solution.
Can you try below:
If its still does not work, recommend to open a TAC case to investigate further.
Can you try below:
If its still does not work, recommend to open a TAC case to investigate further.
Followed these directions and the alert/error remains.
Would recommend to open a TAC case to further investigate the issue, possibly from the back end of the appliance which only TAC engineer has access to it.
I try this and before ENABLE reporting,I enter command DELETEDB and evereything works like before.
Now I have full reporting.
Thanks
what will be the impact if we execute the commands?
Hi :)
The procedure save me.
Thanks
This procedure solved the problem only for a little time. My s170 stopped the logging freqently after a few days. Any ideas
Hi,
S170 has a very limited disk and capacity especially with local reporting enabled, this can burden the appliance heavily depending on how busy the appliance is.
When S170 stopped logging frequently, would recommend to open TAC case for the engineer to review the appliance from the backend and check the services and processes and reporting database. From there the engineer can provide you with recommendation or solution.
Regards
Handy Putra