WSA CLI "STATUS"

[Xuan Truong]

I want to know the "Status" command on the WSA device is to show the status at that time for the device or the device for a certain period of time?
Can anybody help me?

[Xuan Truong]

---

@Marvin Rhoads can you help me? Pls...

[Marvin Rhoads]

Sorry I don't know the answer to this one.

[Xuan Truong]

thank you

[Xuan Truong]

thank you

[Ken Stieers]

CPU/RAM/DISK percentages are all a "current" measurement.

The ones below that are all over the last minute, except for connections which is also "current"

This is the same data shown on the dashboard.

[Xuan Truong]

thank you.

[Handy Putra]

Hi,

Status command will show the status at that particular time that you run the command (Status as of).

Status detail will show you more detail information.

Also in CLI you can use 'rate' command as well to get percentage of prox(just prox - service that use to process web traffic CPU not overall CPU) cpu with number of Requests per second, disk read and write every 10 seconds.

Regards

Handy Putra 

[Xuan Truong]

thank you