WSA HA is swaping to Backup Server

[t.gembler]

Hi

I've got 4 WSA running in HA with Failover group for every vWSA. The HA is working perfect until i upgrade to a newer Async OS (in this case from 10.1.1-230 to 10.1.2-036).

If i reboot the WSA after the upgrade the virtual HA IP is flapping between the Master(Prio 255) and the highest Prio in the Failover Group. Every few seconds it is moving from master to the backup and back to the master ... So in this case the wsa have different OS.      

So i went back to an vm snapshot before the 10.1.2-036 and then the HA is fine again.

Last time i upgraded to 10.1.1-230 i've had the same issue.

Do i make a mistake during the install ? 

Thanks for your replies

Tobias

[andresmen598]

Good day,

I would like to know if there is any document showing the step by step to perform load balancing and HA configuration between a WSA and vWSA through WCCP on a Cisco ASA Firewall.

On the other hand I have the doubt when this type of configuration is done as it is done so that when making some configuration change replicate in the two WSA (physical WSA and virtual vWSA).

Thank you in advance for the collaboration and help you give me.