The Linux driver runs on most distributions, and kernels 2.2.x and 2.4.x are supported. While there is a pre-compiled driver for RedHat 7.1 running kernel 2.4.2-2, the source is included so that binaries can be compiled under any of the supported kernels. It is recommended to use PCMCIA-CS version 3.1.22 or later for the 340 series clients, and 3.1.26 or later for the 350 series clients.
Note: Cisco Aironet CB21AG and PI21AG Client Adapter software is incompatible with other Cisco Aironet Client Adapter software. The Aironet Desktop Utility (ADU) must be used with CB21AG and PI21AG cards, and the Aironet Client Utility (ACU) must be used with all other Cisco Aironet client adapters.
Cisco does not have any Linux drivers that support PI21AG cards.
WLAN adapters (wireless card) / ACU (Aironet Client Utility)
I have three AERONET Aeronet AIR 1832I-E-K9 Wireless AP connected to Catalyst 9200 Switch I dont have any wieless controller. I need to configure them I have assigned them IP using "Capwap ap ip netmask"How can I make them work as an AP and I w...
Using 2x 1562's in this exact setup for bridging. I get to the part for whitelisting the MAC address (done), and enabling bridging (done) but the MAP never joins the RAP, with this error in the CLI: CRIT-MeshAwppAdj: Blacklisting Adjacency due to ...
Hi, Why wlc c9800 is still using version 16.12 though it own version 17.5? Please see the below output. Dont know why boot-start is not working. But another same model wlc is using 17.5 and not using boot-start wlc2#sh run | i bootboot-start-mar...