Cisco Community
English
Register
New community login process starting July 13 - LEARN MORE HERE
Register
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel

Understanding Multicast in Unified Wireless Networks

2177
Views
20
Helpful
1
Comments
Jeffrey Keown
Cisco Employee
‎06-07-2012 06:24 AM
edited on: ‎11-18-2020 ‎02:59 AM
 
Comments
kangupta
Cisco Employee
Cisco Employee
‎04-05-2013 07:27 AM
‎04-05-2013 07:27 AM

Very well explained Jeff!

This was most helpful.

Thank you.

Latest Contents
How can i generate an uptime report for WLC's and AP's ?
Created by SabeelShakeel00430 on 07-26-2021 02:03 AM
3
0
3
0
I am currently trying to figure our how to create an uptime report on Prime, i have created reports for ASA, switches, and routers that show their true uptime (via the Last Boot Time data field), but cant seem to find anything similar for WLC's or AP's.&n... view more
"Could not check supported rates. Invalid Supported Rates fr...
Created by Tony Rosolek on 07-26-2021 01:27 AM
0
0
0
0
Hello Cisco Community, I have two pairs of Cisco 8510 Controllers with software version: 8.5.171.0. These Controllers generate more than 50.000 of the following log messages per hour: [SA]apf_utils.c:219 Could not check supported rates... view more
Low wireless speed cisco air-cap1702i-e-k9 d
Created by poratnir on 07-26-2021 12:10 AM
0
0
0
0
So i had a tough time defining the AP settings cisco air-cap1702i-e-k9 d, I managed to set 2.4Ghz and 5Ghz wireless networks the only issue that speed is extremely low , I have on my direct wifi connection 200MB while in Cisco net bare... view more
Multiple Mobility Express Controller on Same Network
Created by GeraldiRhamadhany32756 on 07-25-2021 10:49 PM
1
5
1
5
hi, I have a 1562i access point that I want to use as a controller but in the same location I have installed another ME Controller with the same type of AP. Is it possible to deploy the same 2 ME Controller in one network?
5G Radio does not broadcast SSID on autonomous 3602
Created by prado94@yahoo.com on 07-25-2021 10:20 PM
0
0
0
0
Hi,My 3602 running 15.3.3JF12i will only broadcast on 802.11N over 2.4G only.  The config I have is: dot11 ssid LM0701band-selectauthentication openauthentication key-management wpa version 2guest-modewpa-psk ascii 7 xxx-snip-interface Dot11Radi... view more
Content for Community-Ad