Make sure that Publicly Secure Packet Forwarding (PSPF) is not enabled.
PSPF prevents client devices associated to a bridge or access point from inadvertently sharing files with other client devices on the wireless network. PSPF provides Internet access to client devices without providing the other capabilities of a LAN.
To enable or disable PSPF, refer to these documents:
To block access between the clients connected to different access points on the same switch configure the ports to which the access points connected as a Protected port. Refer URL Configuring Protected Ports for configuring this.
Associated but cannot pass traffic to some devices
WLAN adapters (wireless card) / ACU (Aironet Client Utility)
I have a WLC 3504 at a central location and six sites that use it, including the site containing the controller. The controller has an Internet breakout on port 2 and LAN access on port 1. I am looking at implementing Flexconnect and have been through the...
Facing this issue, few APs were not working so rebooted the WLC, after reboot no APs were showing, set the Controller to factory defaults, configured as per the cisco guide but no hopepresent situation:WLC 4404, APs:LAP1242AG-E-k9Acess Points are on ...
HI Everyone, I looked at the interface details and noticed that all dynamic-interfaces have the same MAC address. And it is basically the same as the MAC address of the management interface. My WLC is 5508, and I want to know how the Cisco WLC assign...
We are implementing a VLAN in a confined environment which combines both wired and wireless connections. We currently have multiple Full HD (1920x1200) video cameras, each streaming >3.3Gbps, so we are using 10Gig switch over RJ45. The video is multica...