About nicholas.pace

nicholas.pace · 08-26-2011

Good morning,I have 2 CRS-1 Routers configured for HSRP which act as default gateway to 4 Cisco 2511 network consoles. In this configuration, we have asymmetrical routing setup, so inbound traffic goes from R1 ----- towards cisco 2511 network consol...

nicholas.pace · 08-26-2011

Yup I agree with ya Jon. Thanks to both of you for helping out here. I will follow up on this thread when I have a chance to capture packets.Thanks again

nicholas.pace · 08-26-2011

Current configuration : 17642 bytes!! Last configuration change at 11:43:11 PDT Fri Aug 26 2011 by npace! NVRAM config last updated at 11:43:14 PDT Fri Aug 26 2011 by npace!version 12.2no service padservice timestamps debug datetime msec localtime sh...

nicholas.pace · 08-26-2011

the port connecting to mpls is setup in a port channel as such:3750#interface GigabitEthernet1/0/1 switchport trunk encapsulation dot1q switchport mode trunk speed nonegotiate channel-group 1 mode activeendinterface Port-channel1 switchport trunk en...

nicholas.pace · 08-26-2011

Hi Ameya,I really think this is a problem with the 3750. Reason being is that when I take it out of the picture, I have no problems. The routers do have a direct connection between one another.The switches here (3750, Alcatel) are on the same layer...

nicholas.pace · 08-26-2011

Hi Jon,The routers are connected via Alcatel MPLS (only using layer 2). STP is not enabled on any of these devices and layer 2 redundancy is handled by alcatel. the 3750 is connected to both routers via mpls. hsrp is not enabled on the 3750, and t...

Member Since	‎08-26-2011 07:54 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	7

User Statistics

User Activity

Asymmetrical Routing + ARP + HSRP issue

Re: Asymmetrical Routing + ARP + HSRP issue

Re: Asymmetrical Routing + ARP + HSRP issue

Asymmetrical Routing + ARP + HSRP issue

Asymmetrical Routing + ARP + HSRP issue

Asymmetrical Routing + ARP + HSRP issue