Hi, Just a quick question if anybody has run into a bug where the ASAs "timeout" settings are not being applied to idle connections. It seems that our ASA running the software level 8.4(6)5 is not tearing down connections. This mainly seems to be a p...
Hi, Just want a quick confirmation on what is the status on the getting the Notifications to work for a certain section of the CSC? I was personally subscribed to the Firewall and VPN sections and some other sections of the CSC to get ALL updates rel...
Hi, Seems to me that the notifications of new discussions started in the CSC sections to which I subscribe to are not being sent to me. For me this is essential as I tend to only check the forums when I get the notifications. But to my understanding ...
Hi,As the title says, seems all the old information from the "All Time" statistics of "Leaderboards" have gotten wiped for both internal and external users while the "Current Month" statistics have stayed intact. - Jouni
Hi,Seems to me that the Leaderboards page hasnt resetted after the month changed?Similiar thing happened at the change from May to June. Even though the Leaderboards resetted, it stopped updating right after the reset.- Jouni
Hi,
Not 100% sure about the current situation but to my understanding there would be nothing that would replace the mentioned module. I would assume that as the original ASA5500 Series interface module was let go of at the same time as the ASA5500 d...
Hi,
Presuming that all the "object" configurations have the "host 192.168.8.11" under them then I it seems to me that the only problem is in your "access-list" configurations.
Please remove the source ports that you have defined in your current "ac...
Hi,
So essentially you need to configure NAT so that both your VPN Client users and LAN users need to be visible from the same /29 sized subnet allocated to you by the remote end admin of the L2L VPN Connection?
In the past I have used the followin...
Hi,
I am not sure what this has to do with VPNs other than using the port TCP/443
I assume your problem is that both the ASDM and SSL VPN on an ASA firewall use the port TCP/443?
If that is the problem then you could naturally change both the ASDM ...
Hi, You could first check if the ASA sees anything on the "outside" interface regarding ARP show arp | inc outside Confirm that you can see the gateway IP address 10.0.0.2 there. If not you can try to ping it from the ASA and then check the output of...