About ohassairi

ohassairi · 01-05-2021

hello i have the following scenario: PC1 (192.168.1.1) + PC 2 (192.168.1.2) connected to swsw connected to outside interface of Router (192.168.1.254)inside interface of router (172.20.70.254) connected to server 172.20.70.1i need the router to make ...

ohassairi · 09-20-2018

dears is it possible to implement WSA in explicit mode and spoofing enabled . i think this will not work if the web site is ipv4 only. because: wsa could not initiate a traffic with IP-source v6 (client IP) and IP-destination v4. this will not work o...

end user addressing with BGP · 09-03-2018

hi we are planing to implement dual stack. in internet edge we have 2 routers (hsrp) connected to our ISP 2 routers. (one ISP having 2 routers for redundancy) we use BGP. in case ISP line 1 goes down traffic will be redirected to ISP line2. ----R1...

ohassairi · 03-18-2018

We are asked to deploy IPv6 in dual stack in our network in order to enhance our IPv6 rank . As we are new with this technology can you guide us? Shall we Address all our internal network with public IPv6 addresses in order to enhance our rank ? ...

ohassairi · 03-15-2018

HiWe are asked to deploy IPv6 in dual stack in our network in order to enhance our rank . Shall we Address all our internal network with public IPv6 addresses in order to enhance our rank ? is there any security issue in doing so? Is NAT still used...

ohassairi · 01-13-2021

why do you think the delay is from the networkin many cases the delay is from the server.

ohassairi · 01-05-2021

actually, i found that :ip nat inside source static 172.20.70.1 10.79.1.1 route-map rm1 will apply the route-map only for traffic coming to inside interface so if server sends traffic to 192.168.1.1 nat will happen but if the destination is 192.168...

ohassairi · 01-05-2021

10.79.1.1 is the NAT ip of internal server 172.20.70.1ip nat inside source static 172.20.70.1 X.x.x.x is not enough because it will make nat with both PCsi need to make NAT only for traffic between PC1 and server, that's why i added route-map

ohassairi · 03-05-2020

do you have ip proxy-arp configured ?

ohassairi · 04-15-2018

sur quel port tu as connecte le cable de casacde ? car je vois toutes les interfaces down: FastEthernet0 unassigned YES unset down down FastEthernet1 unassigned YES unset down down FastEthernet2 unassigned YES unset down down FastEthernet3 unassign...

Member Since	‎09-27-2006 01:05 AM
Date Last Visited	‎01-14-2021 09:56 PM
Posts	650
Total Helpful Votes Received	200

User Statistics

User Activity

NAT with route-map

dual stack / wsa explicit / spoofing

end user addressing with BGP

IPv6 dual stack deployment

IPv6 dual stack

Re: Cisco Switch 2950/2960 Latency Issue

Re: NAT with route-map

Re: NAT with route-map

Re: Excesssive arp entried due to static routes

Re: le router cisco 887 VA-K9 ne diffuse pas les adresses IP au reseau local