C9300X-48TE after stack shows no exist interface

[willy-liu]

Hi Guys,

We have three C9300X-48TE , do the stack , and after I finished the stack , I do the "sh ip int bri" and "sh run"

the C9K SW shows that more interface no exist, it's means I didn't add the module but shows up

the more detail information

Switch Ports Model SW Version SW Image Mode
------ ----- ----- ---------- ---------- ----
* 1 78 C9300X-48TX 17.12.04 CAT9K_IOSXE INSTALL  >>> with no module
2 78 C9300X-48TX 17.12.04 CAT9K_IOSXE INSTALL    >>> with "8x25G Uplink Module"
3 78 C9300X-48TX 17.12.04 CAT9K_IOSXE INSTALL    >>> with "4x100G/40G Uplink Module"

----------------------------------------------

the error example , when I do the "sh ip int bri" the SW1 shows Te1/1/1.....TwentyFiveGigE1/1/1 those no exist interface

does anyone have solution to fix it ??

[Leo Laohoo · Accepted solution]

That is normal because the ports will become active when the interface(s) go up.

[willy-liu]

Hi Leo ,

so even I didn't pluged the module on C9K , when I show ip int bri , will shows those not exist interface ??

[Leo Laohoo]

Yes.  They will show up.  This is nothing to be of concern.