思科2911路由器，想做限速，大俠們看看問題出在哪？

[liming581796]

詳情：
JM_A1-2911A#config t
Enter configuration commands, one per line. End with CNTL/Z.
JM_A1-2911A(config)#class-map match-all 30
JM_A1-2911A(config-cmap)#match access-group 30
JM_A1-2911A(config-cmap)#policy-map xiansu
JM_A1-2911A(config-pmap)#class 30
JM_A1-2911A(config-pmap-c)#police 5120000 16000 conform-action transmit exceed-action drop
JM_A1-2911A(config-pmap-c-police)#interface FastEthernet0/1
^
% Invalid input detected at '^' marker.
路由器接口：
Interface IP-Address OK? Method Status Protocol
Embedded-Service-Engine0/0 unassigned YES NVRAM administratively down down
GigabitEthernet0/0 221.13.144.42 YES NVRAM up up
GigabitEthernet0/1 10.1.0.254 YES NVRAM up up
GigabitEthernet0/2 unassigned YES NVRAM administratively down down
NVI0 221.13.144.42 YES unset up up
Tunnel368 10.133.252.186 YES NVRAM up up

[fortune · Accepted solution]

你没有F口当然进不了，你全局模式下 int g0/0 就进得了

[YilinChen]

亲，你的ACL呢？
设备都是G口，为什么想进入FE口进行配置？
JM_A1-2911A(config-pmap-c-police)#interface FastEthernet0/1
^
% Invalid input detected at '^' marker.
路由器接口：
Interface IP-Address OK? Method Status Protocol
Embedded-Service-Engine0/0 unassigned YES NVRAM administratively down down
GigabitEthernet0/0 221.13.144.42 YES NVRAM up up
GigabitEthernet0/1 10.1.0.254 YES NVRAM up up
GigabitEthernet0/2 unassigned YES NVRAM administratively down down
NVI0 221.13.144.42 YES unset up up
Tunnel368 10.133.252.186 YES NVRAM up up

[liming581796]

謝謝親的回復，也試了G口的，也是一樣！interface GigabitEthernet0/1
ALC
JM_A1-2911A#show ip access-list
Extended IP access list iinternet
Extended IP access list interner
Extended IP access list internet
10 permit ip 10.1.0.0 0.0.0.15 any (1047444 matches)
20 permit ip 10.1.0.16 0.0.0.3 any
30 permit ip host 10.1.0.232 any (1057541 matches)
40 permit ip host 10.1.0.233 any (206 matches)
50 permit ip host 10.1.0.234 any (5828 matches)
60 permit ip host 10.1.0.235 any (77601 matches)
70 permit ip host 10.1.0.236 any (53196 matches)
80 permit ip host 10.1.0.237 any (31531 matches)
90 permit ip host 10.1.0.70 any (27887 matches)
100 permit ip host 10.1.0.80 any (19541 matches)
110 permit ip host 10.1.0.81 any (27162 matches)
120 permit ip host 10.1.0.90 any (10042 matches)
130 permit ip host 10.1.0.82 any (26008 matches)
140 permit ip host 10.1.0.83 any
150 permit ip host 10.1.0.84 any (47506 matches)
160 permit ip host 10.1.0.85 any (2792 matches)
170 permit ip host 10.1.0.86 any
180 permit ip host 10.1.0.93 any (15484 matches)
190 permit ip host 10.1.0.94 any (61682 matches)
200 permit ip host 10.1.0.71 any (27168 matches)
210 permit ip host 10.1.0.72 any (1890 matches)
220 permit ip host 10.1.0.73 any (5933 matches)
230 permit ip host 10.1.0.74 any (8991 matches)
240 permit ip host 10.1.0.75 any (11096 matches)
250 permit ip host 10.1.0.95 any (4906 matches)
260 permit ip host 10.1.0.91 any (805 matches)
270 permit ip host 10.1.0.92 any (27351 matches)
280 permit ip host 10.1.0.96 any (2899 matches)
290 permit ip host 10.1.0.69 any (34533 matches)
300 permit ip host 10.1.0.238 any (179188 matches)
310 permit ip host 10.1.0.68 any (14442 matches)

[liming581796]

YilinChen 发表于 2016-8-8 10:45
亲，你的ACL呢？
设备都是G口，为什么想进入FE口进行配置？

謝謝親的回復，也試了G口的，也是一樣！interface GigabitEthernet0/1
ALC
JM_A1-2911A#show ip access-list
Extended IP access list iinternet
Extended IP access list interner
Extended IP access list internet
10 permit ip 10.1.0.0 0.0.0.15 any (1047444 matches)
20 permit ip 10.1.0.16 0.0.0.3 any
30 permit ip host 10.1.0.232 any (1057541 matches)
40 permit ip host 10.1.0.233 any (206 matches)
50 permit ip host 10.1.0.234 any (5828 matches)
60 permit ip host 10.1.0.235 any (77601 matches)
70 permit ip host 10.1.0.236 any (53196 matches)
80 permit ip host 10.1.0.237 any (31531 matches)
90 permit ip host 10.1.0.70 any (27887 matches)
100 permit ip host 10.1.0.80 any (19541 matches)
110 permit ip host 10.1.0.81 any (27162 matches)