ISR4331配置QOS

[禾啸宏]

配置qos时，需要

priority跟

police同时调用，现在在敲完配置命令后会报以下报错：

police and priority with bandwidth/percent are not allowed in the same class
具体配置如下：
ROUTER(config-pmap)#class data
ROUTER(config-pmap-c)#priority percent 30
ROUTER(config-pmap-c)#police cir percent 30
police and priority with bandwidth/percent are not allowed in the same class
ROUTER(config-pmap-c)#

[junnyang]

IOS-XE platform does not support two policers configured on the same class.
You can use the following commands:
policy-map test123
class test123
priority
police cir percent 30
conform-action transmit
exceed-action drop
I hope the above helps
Best Regards,
Johnny

[Rockyw]

楼主参考一下下面的文档
Solved: Police and Priority with bandwidth/percent are not allowed in the same class
https://community.cisco.com/t5/r ... wed-in/td-p/2462392
Solved: QOS Service Policy Bandwidth percent values not as expected.
https://community.cisco.com/t5/r ... pected/td-p/2395878