There are these two switches.
1. When connected using the downlink port, the link comes up normally.
ex) c1000fe24T(fa1/0/1) ↔ C1000fe48T (fa1/0/1)
2. However, if you connect using an uplink port, the link does not come up.
ex) c1000fe24T(gi1/0/1) ↔ C1000fe48T (gi1/0/1)
In both cases, the same UTP cable was used, and the interface setting is the trunk setting only.
The question is, I wonder what setting should be made for UTP cable when using combo port.
For example, [media-type Rj-45] Do you need a command like this to connect..
