날짜: 07-27-2023 07:00 PM
The following command to filter and send route information in the out direction cannot be executed.
It seems that filtering is done only in the in direction. Is the filtering function in the out direction gone?
router ospf 1
network 10.0.0.0 0.255.255.255 area 0
distribute-list 1 out GigabitEthernet0/1
exit
ip access-list standard 1
deny 192.168.10.0 0.0.0.255
permit any
해결되었습니다! 솔루션으로 이동.
날짜: 07-27-2023 07:24 PM
The configuration is right. But this command only works on the routes being redistributed by Autonomous system boundary Router into OSPF. It can be applied to external type 2 and type 1 routes, but not to intra-area and interarea routes..
07-27-2023 07:09 PM - 편집 07-28-2023 06:31 AM
Check below
날짜: 07-28-2023 06:27 AM
Thank you for answer. However, I need a function to distribute by setting an access list with a specific interface.
07-28-2023 06:33 AM - 편집 07-28-2023 06:39 AM
Yes I test with interface also' but it depend on prefix and direction
R1 - R2
R1 distribute out NOT filter intra and inter area
R2 distribute in filter any prefix
That what I want to show in lab
Anyway
Have a nice summer
MHM
날짜: 07-27-2023 07:24 PM
The configuration is right. But this command only works on the routes being redistributed by Autonomous system boundary Router into OSPF. It can be applied to external type 2 and type 1 routes, but not to intra-area and interarea routes..
새로운 아이디어를 발견하고 저장하세요. 전문가 답변, 단계별 가이드, 최근 주제 등 다양한 내용을 확인해 보세요.
처음이신가요? 아래 팁들을 확인해 보세요. 시스코 커뮤니티 사용하기 새 멤버 가이드