Outbound distribute-list

[ByungGakJo3436]

The following command to filter and send route information in the out direction cannot be executed.
It seems that filtering is done only in the in direction. Is the filtering function in the out direction gone?

router ospf 1
network 10.0.0.0 0.255.255.255 area 0
distribute-list 1 out GigabitEthernet0/1
exit

ip access-list standard 1
deny 192.168.10.0 0.0.0.255
permit any

[MHM Cisco World]

Check below 

[ByungGakJo3436]

Thank you for answer.  However, I need a function to distribute by setting an access list with a specific interface.

[MHM Cisco World]

Yes I test with interface also' but it depend on prefix and direction

R1 - R2 

R1 distribute out NOT filter intra and inter area 

R2 distribute in filter any prefix 

That what I want to show in lab 

Anyway 

Have a nice summer 

MHM

[Flavio Miranda · Accepted solution]

Hi @ByungGakJo3436 

 The configuration is right. But this command only works on the routes being redistributed by Autonomous system boundary Router into OSPF. It can be applied to external type 2 and type 1 routes, but not to intra-area and interarea routes..