cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
10745
Views
15
Helpful
8
Replies

ACI and Netflow

eugenia
Beginner
Beginner

Can an ACI fabric export netflow data and if so are there any configuration guides/examples?

1 Accepted Solution

Accepted Solutions

dpita
Cisco Employee
Cisco Employee

Hello!

Thanks for using support forums!

Netflow support will be coming out in December/January timeframe. Look forward to some configuration documents then!

View solution in original post

8 Replies 8

seems like not. They suggest to send traffic sampling using ERSPAN and then convert it into netflow.

Vladimir, Thank you for responding and confirming.  I was not sure that was still the case!

dpita
Cisco Employee
Cisco Employee

Hello!

Thanks for using support forums!

Netflow support will be coming out in December/January timeframe. Look forward to some configuration documents then!

milwrigh
Beginner
Beginner

It's Feb now...is NetFlow exports supported? If so, can you send link to docs?

Thanks

Netflow configuration videos released on the ACI youtube channel this week:

Part 1 - https://www.youtube.com/watch?v=6Yl_GelaS7g

Part 2 - https://www.youtube.com/watch?v=LQCZdf9Sux0

scherrav
Cisco Employee
Cisco Employee

The Config guide for Netflow with ACI is out now

Please see

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/kb/b_KB_Cisco_APIC_and_NetFlow.html

H Scherrav,

 

What is the difference in between configuring a Fabric Netflow policy and Tenant Netflow policy? Is this supposed to configure both? or either one will suffice? And I am a bit confused on what is the purpose of EPG Type, Associated EPG and Associated VRF?

yan.peyer
Beginner
Beginner

Why do I have to set a /20 network for the source? Is there any other way to set a single /32 address? 

 

apic1(config-tn-flow-exporter)# source address
inband-mgmt-ip oob-mgmt-ip ptep
apic1(config-tn-flow-exporter)# source address 1.1.1.1 ?
<CR>
apic1(config-tn-flow-exporter)# source address 1.1.1.1
Error: Source address can have a mask upto 20 and 116 for ipv4 and ipv6 addresses respectively
Command execution failed.
apic1(config-tn-flow-exporter)# source address 1.1.0.0/20
apic1(config-tn-flow-exporter)# no source address

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: