cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
12288
Views
15
Helpful
8
Replies

ACI and Netflow

eugenia
Level 1
Level 1

Can an ACI fabric export netflow data and if so are there any configuration guides/examples?

1 Accepted Solution

Accepted Solutions

dpita
Cisco Employee
Cisco Employee

Hello!

Thanks for using support forums!

Netflow support will be coming out in December/January timeframe. Look forward to some configuration documents then!

View solution in original post

8 Replies 8

seems like not. They suggest to send traffic sampling using ERSPAN and then convert it into netflow.

Vladimir, Thank you for responding and confirming.  I was not sure that was still the case!

dpita
Cisco Employee
Cisco Employee

Hello!

Thanks for using support forums!

Netflow support will be coming out in December/January timeframe. Look forward to some configuration documents then!

milwrigh
Level 1
Level 1

It's Feb now...is NetFlow exports supported? If so, can you send link to docs?

Thanks

Netflow configuration videos released on the ACI youtube channel this week:

Part 1 - https://www.youtube.com/watch?v=6Yl_GelaS7g

Part 2 - https://www.youtube.com/watch?v=LQCZdf9Sux0

scherrav
Cisco Employee
Cisco Employee

The Config guide for Netflow with ACI is out now

Please see

http://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/kb/b_KB_Cisco_APIC_and_NetFlow.html

H Scherrav,

 

What is the difference in between configuring a Fabric Netflow policy and Tenant Netflow policy? Is this supposed to configure both? or either one will suffice? And I am a bit confused on what is the purpose of EPG Type, Associated EPG and Associated VRF?

yan.peyer
Level 1
Level 1

Why do I have to set a /20 network for the source? Is there any other way to set a single /32 address? 

 

apic1(config-tn-flow-exporter)# source address
inband-mgmt-ip oob-mgmt-ip ptep
apic1(config-tn-flow-exporter)# source address 1.1.1.1 ?
<CR>
apic1(config-tn-flow-exporter)# source address 1.1.1.1
Error: Source address can have a mask upto 20 and 116 for ipv4 and ipv6 addresses respectively
Command execution failed.
apic1(config-tn-flow-exporter)# source address 1.1.0.0/20
apic1(config-tn-flow-exporter)# no source address

Review Cisco Networking for a $25 gift card

Save 25% on Day-2 Operations Add-On License