Hi Everyone
I have an ACI Fabric infrastructure with 2 Spines, 6 leaf's and 3 APIC controller, each controller should be connected to a pair of Leaf as follow
APIC-1 to Leaf 1 and 2
APIC-2 to Leaf 3 and 4
APIC-3 to Leaf 5 and 6
The issue begins when due to a logistical problems I cannot connect the APIC-3 to its own leaf's, so I had to connect the APIC-3 to the Leaf's 1 and 2, after being able connect my APIC-3 to the leaf's 5 and 6, the ports where this APIC-3 was connected are now put in (out-of-service) state when I try to use it to another connection such as a Server, a Switch, and so on, also I cannot configure anything on these ports
Any Idea to "clean" these ports?
Thanks in Advance
