APIC CLI: GIPo Network is only visible in APIC1

[Jens Haunschild]

Hello everyone,

we have a ACI Multipod solution and now i have question about the APIC CLI.

If we try to reads the BASIC parameters via CLI from the APIC with the Command "cat sam_exported.config" we can see

all the BASIC Parameters on the first APIC.

If we repeat this on the other 2 APICs in the Cluster, we notice that the GIPo Network s missing.

Is this the normal state or is this an issue? 

maybe someone have an idea to this state.

Greetings

Jens

[Sergiu.Daniluk · Accepted solution]

Yes, it's expected. I have seen the same behavior in 5.2. Older versions had the gipo present on all apics.

Stay safe,

Sergiu

[Jens Haunschild]

Hi Sergiu,

thanks for your answer!

Jens