APIC-EM C220M4 LACP Query

[michael.taylor]

Hello Fellow Networkers,

We are rebuilding a three appliance cluster operating APIC-EM Version 1.6.0.30151 and need clarification on the wisdom of my actions.

During the GUI install I did not assign an VLAN ID to bond0 VNIC 1 (management interface) of a LACP bonded pair of Gigabit ports, but did assign IP addressing.  We assigned VLAN 888 to a bond0: Virtual NIC2 and populated with an accessible range of addresses.  Following completion we can fully manage the appliance via bond:0 VNIC 2, but have no access to bond0: VNIC 1 IP range.  I have tried setting the native VLAN on the neighbouring switch trunk port but I’m not seeing any MACs other than that associated with bond0: VNIC2 (VLAN 888).

What’s the recommended corrective action other than a “config_wizard”?

Pearls of wisdom would be much appreciated.

Thanks in anticpation.

[Rick1776]

The following link will help you. You Basically have to go through the APIC CLI.

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/1-x/cli/nx/cfg/b_APIC_NXOS_CLI_User_Guide/b_APIC_NXOS_CLI_User_Guide_chapter_01000.html#task_863DDD89897A449A8B857F04B340D956

[michael.taylor]

Hello Rick,

Prompt response much appreciated.

Unfortunately, the Cisco C220M4 APIC Enterprise Module does not have a CLI interface.  To the best of my knowledge the grapevine triggered config_wizard is our sole configuration tool asside from the GUI.. unless you know diffiferent?.

Thanks

[Rick1776]

I’m so sorry I thought this was for APIC in ACI not EM.

It looks like your correct the only way is via the wizard.

I did find this link.
https://cisco-marketing.hosted.jivesoftware.com/message/220865?mobileredirect=true