04-19-2021 04:42 AM
Hi there
I have one ACI fabric with some configuration done. When i shutdown whole Fabric including APIC Cluster and all switches. Then i power on all them again. All switches remain in Inactive status. Can somebody tell me why?
04-19-2021 04:59 AM
There's not enough information provided to begin to guess. What was the order you powered down/up fabric devices? Which version are you running? Can APIC see the Switches via LLDP? How many controllers?
Robert
04-19-2021 05:13 AM
I shuttdown the apic from the GUI and gracefully. Then I power off the switches.
Apic version is 5.0
Show lldp command shows nothing. I tested it using 1 apic alone and with apic cluster.
04-19-2021 05:20 AM
From the APIC CLI run:
acidiag run lldptool in eth2-1
acidiag run lldptool in eth2-2
Robert
04-19-2021 05:43 AM
Agent instance for device not found 7f
04-19-2021 06:04 AM
Use ifconfig, and find out the interfaces of the APIC used for fabric uplinks. Then repeat the command above for them.
Robert
04-19-2021 05:40 AM
if you connect to each APIC, do you see the same behavior on all of them?
04-19-2021 05:56 AM
Yes. In addition to version 5. I have same problem with vwrsion 4.2.4
any config needed to do for apic faced interfaces?
04-19-2021 06:04 AM
I exactcly do nothing after fabric discovery. Something missed?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: