Easiest way to "stop" using a ACI PBR Service Graph

[joeharb]

We are deploying a POC for a one armed FTD using Service Graph with PBR.  I would like to know the easiest way to "stop" the traffic from flowing through the FTD without removing the Service Graph.  I know I can change the contract ports to stop specific traffic but didn't know if there was an easier to keep everything in tact but stop using the service graph between the 2 EPGS.

Thanks,

Joe

[Robert Burns]

Joe,

You can just remove the ServiceGraph association within the contract's subject, which will let the traffic flow directly rather than redirecting.  When you want to go back to PBR, simply re-bind the SG instance again.  

Robert

[Benslove254]

Hi there! It sounds like you're looking to stop using a Cisco ACI
Policy-Based Redirect (PBR) Service Graph. To do that, you can remove the
Service Graph association from the contract's subject. This will allow the
traffic to flow directly instead of being redirected. If you want to use
PBR again in the future, you can simply re-bind the Service Graph instance.
Let me know if you need more assistance!

[Benslove254]

No am not trying to stop doing that