02-17-2023 12:33 AM - edited 02-17-2023 12:38 AM
Hi ,
I just upgraded My APICs from 5.2(3e) to 5.3(2f) upgrade went smooth with no issues ,
When I tried to start upgrading the Fabric as Below :
During validation i received the below critical issue :
Before I continue I double checked that the Image is synchronized on ll APIC which was the Case :
but at the End update fails , Any Idea why and what to do to resolve it ?
Also , Note this is a 4 pod deployment and the Pod I am trying to upgrade is not directly connected to the APIC.
Solved! Go to Solution.
02-17-2023 05:20 AM
How long did you wait after upgloading the Switch image to the APIC before attempting an upgrade? It will take time to sync, and depending on the interpod bandwidth may take a bit. If its been hours and still showing this message I'd suggest deleting that switch image, and re-uploading it.
Robert
02-17-2023 05:20 AM
How long did you wait after upgloading the Switch image to the APIC before attempting an upgrade? It will take time to sync, and depending on the interpod bandwidth may take a bit. If its been hours and still showing this message I'd suggest deleting that switch image, and re-uploading it.
Robert
02-18-2023 11:12 PM
Thanks Robert That works ,
Another Issue came up is One of the Spines is Completely unreachable now after the upgrade
How Can I rollback ?
What troubleshooting Actions I can take ?
Regards
Amr
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide