how to check tunnel interface details in ACI cli ?

[Network_Sarovani]

Hello Experts , 

I am trying to trace the endpoint 10.10.10.18 from source connected leaf switch .From the below output I can see to reach  10.10.10.18 we have to go via tunnel23 ...

How do I check next from cli ? what is the command to check the tunnel 23 ?

GER-DC-LF101# show endpoint ip 10.10.10.18
Legend:
s - arp H - vtep V - vpc-attached p - peer-aged
R - peer-attached-rl B - bounce S - static M - span
D - bounce-to-proxy O - peer-attached a - local-aged m - svc-mgr
L - local E - shared-service
+-----------------------------------+---------------+-----------------+--------------+-------------+
VLAN/ Encap MAC Address MAC Info/ Interface
Domain VLAN IP Address IP Info
+-----------------------------------+---------------+-----------------+--------------+-------------+
SAROVANI:VRF-PROD 10.10.10.18 tunnel23 

[Network_Sarovani]

Hi Expert , 

Can anyone check and share your inputs .

[Robert Burns]

I'd recommend you check out the Cisco live Session; BRKACI-2641 ACI Troubleshooting Endpoints.  https://www.ciscolive.com/on-demand/on-demand-library.html?search=BRKACI-264#/session/16360600240670017cef
It will answer this and help you when debugging endpoint connectivity issues.

Robert

[Network_Sarovani]

Hi , I did not find any info regarding tunnel and the commands to check it.

[Sergiu.Daniluk · Accepted solution]

You can use the following commands:

"show interface tunnel 23" -> to check the destination TEP IP

"acidiag fnvread" to check which leaf has that TEP IP.

Take care,

Sergiu