L3OUT Static Route has No path found.

[john.heard]

Hi,

I have configured a new static L3OUT from which I have added a few subnets, 64/65/66.0/24.  I can see all 3 static route entries in the correct vrf routing table from the cli on the leaf (Nexs 9000).  I can iping to all but one of the subnets (64.0/24), also itraceroute fails and returns the message "No path found."

When I do the same for the other 2 subnets I get a path shown, ie. 1: TEP  10.0.46.95  intf  unspecified  0.000ms

Any ideas as to what may be the issue would be much appreciated.

Thanks

John

[eabiamuwe]

Not sure if I should start a new thread but I too I have an L3OUT static route problem.
- Does any one have any Document that specifically explain creating a L3OUT through a static route?
- The static route next-hop element is sitting in a BD and reachable by leaf's SVI
- I could not distribute this static route prefix into another existing EIGRP process running on a different L3OUT in the same VRF