05-03-2018 11:13 AM - edited 03-01-2019 05:32 AM
Hi,
I have 2 Leaf and 2 spine switch and 3 node cluster.
This is a new cluster so i added only i node.
One leaf and one spine has been discovered by APIC but it is not detecting other leaf.
Tried rebooting,chnaged cable,restart dhcp on APIC.but no luck.
Now come to you for help.
Please let me know what could be the reason.
05-03-2018 07:21 PM
Hi,
Have you registered the first spine and did it get an IP from the dhcp pool. If so, from the spine, check if it can see the second leaf through LLDP. # show lldp neighbors
A clean reload of the leaf might help. Console in to the leaf and run below commands.
#setup-clean-config.sh
#reload
-GK
05-03-2018 10:52 PM
I would also console into the leaf that is not getting discover and make sure the version of code is not too new or too old or even check that is not running in NXOS mode.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide