cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

1462
Views
0
Helpful
2
Replies
ju.mahieu
Beginner

ACI - How to display a fault if CRC or Input Error counters increase.

APIC Version : 3.0.2n

Hi,

My use case is quite simple but I don't know really how to do that.

I would like to display a "fault" if CRC or Input Error are detected on any physical interfaces. 

 

The "Monitoring Policies" seems to be the good way but I need your advice to configure it properly.

Thank you.

Regards,

Ju

 

 

 

 

2 REPLIES 2
b.vanderkolk
Beginner

you've probably already found it but for anyone that is reading this post, you can view them in the GUI or via CLI..

 

https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/4-x/troubleshooting/Cisco-APIC-Troubleshooting-Guide-42x/m-viewing-crc-error-counters.html

 

ecsnnsls
Beginner

You can configure the threshold under the default Monitoring policy under Fabric Policies -> Monitoring -> default -> Stats Collection Policies.

Select Monitoring Object "Layer 1 Physical Interface Configuration (l1.PhysIf) and choose Ingress Drop Packers from the Stats Type dropdown

Click on the + button to configure thresholds and edit threshold for Ingress Error Drop Packets rate. You can set your custom values here.

 

- Rising Thresholds —Triggered when the value exceeds the threshold

- Falling Thresholds —Triggered when the value drops below the threshold.

- The set value specifies when a fault is triggered; the reset value specifies when the fault is cleared.

 HTH

Content for Community-Ad