cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

798
Views
0
Helpful
1
Replies
Yousef Askool
Beginner

ACE 30 GUI

Hellow Everyone .

i have configure new ACE 30 module on top of 6500 core switch , the issues am facing whenver i want to access to https://ACE_IP

and after i enter the user name and the password , it's forwared me to the follwoing page :

1-13-2013 6-48-22 PM.jpg

is there anything should i configure to avoid this page ?

Regards

Yousef Askool .

1 ACCEPTED SOLUTION

Accepted Solutions
Francesco Casotto
Cisco Employee

Hello Yousef,

from your post I understand that you would expect to find a GUI to configure the ACE by pointing the browser to its management ip address, is this what you meant?

If so, I need to inform you that the ACE modules so ACE10/20/30 do not integrate a GUI, only the ACE appliance does, what you access by the browser is a set of config migration tools designed to assist in the migration from older Cisco loadbalancers.

If you'd like to use a GUI to configure the ACE modules you should then consider the ANM product:

http://www.cisco.com/en/US/products/ps6904/index.html

which you should be able to obtain free of charge (see FAQ below):

http://www.cisco.com/en/US/prod/collateral/contnetw/ps5719/ps6904/qa_c67-572613.html

Hope this clarifies,

Francesco

View solution in original post

1 REPLY 1
Francesco Casotto
Cisco Employee

Hello Yousef,

from your post I understand that you would expect to find a GUI to configure the ACE by pointing the browser to its management ip address, is this what you meant?

If so, I need to inform you that the ACE modules so ACE10/20/30 do not integrate a GUI, only the ACE appliance does, what you access by the browser is a set of config migration tools designed to assist in the migration from older Cisco loadbalancers.

If you'd like to use a GUI to configure the ACE modules you should then consider the ANM product:

http://www.cisco.com/en/US/products/ps6904/index.html

which you should be able to obtain free of charge (see FAQ below):

http://www.cisco.com/en/US/prod/collateral/contnetw/ps5719/ps6904/qa_c67-572613.html

Hope this clarifies,

Francesco

View solution in original post