ACE Syslog message for State change

[Bilal Nawaz]

Hi,

Is there a syslog message for a state-change for rservers, if so how could we enable this?

e.g. when probe fails state changes to 'probe-failed'

when all probes are successful state is 'operational'

Thank you

Bilal

[ajayku2]

Hi,

There is a syslog message something like below:

%ACE-3-251006: Health probe failed for server 10.80.10.10 on port 80 internal error: failed to setup a socket.

First enable logging on ACE.

ACE/Admin(config)# logging enable

http://www.cisco.com/en/US/docs/app_ntwk_services/data_center_app_services/ace_appliances/vA1_7_/configuration/system/message/guide/config.html#wp1063750

read the section:  Specifying Syslog Output Locations

logging buffered 3 should generate syslog in event of probe failure. 

You can also set snmp to monitor it. 

cesRealServerStateChange

CISCO-ENHANCED- SLB-MIB

State of a real server configured in a server farm changed to a new  state as a result of something other than a user intervention. This  notification is sent for situations such as ARP failures, probe  failures, and so on.

Hope that helps.

regards,

Ajay Kumar