Application Networking

Hi all , One of my WAVE-274 has this alarm :CMS status is offline.It appears offline on the central manager GUI but it is reachable by Telnet . This is the message I get when logging :System Initialization Finished.Disk based software not installed.S...

We have to use no normalization, no icmp-guard on ACE 5(2.0) to allow a One-Arm config to allow asymmetric traffic, i.e. everything of some rservers needs to go through the alias ip.Now this works but the connection table fills up pretty quickly and ...

Hi all,I have Ace 4710 version A4.1.1 and I am experiencing interesting problem with GUI and SSH reachability. I am unable to connect to management vlan3000. Interesting is that I can ping from ACE to network but unable to ping or SSH or HTTPS to ACE...

HiIs the dynamic port range server load balancing supported for MS Exchange 2010Sent from Cisco Technical Support iPhone App

Hello,I am trying to configure sticky on an ACE 4710 and don't understand what the netmask part of the sticky ip-netmask netmask address {source | destination | both } name command.Some examples use 255.255.255.255 and others use 255.255.255.0 but I ...

                   We did a faulty ACE30 module swap in a HA pair. Both the ACEs have stopped syncing since then. Below is the error message I see:FT Group ID: 1  My State:FSM_FT_STATE_ACTIVE    Peer State:FSM_FT_STATE_STANDBY_CONFIG                C...

                   i don't know why cu need this feature, he want stickiness based on source ip and source port.                    Does CSS 11500 support stickiness based on source IP and source port?                   or is there any other method t...

Hi,Is there a syslog message for a state-change for rservers, if so how could we enable this?e.g. when probe fails state changes to 'probe-failed'when all probes are successful state is 'operational'Thank youBilal

Hi,we have a configuration as follows:VIP/port1 -> rserver1/port11 |  rserver2/port21VIP/port2 -> rserver1/port12  |  rserver2/port22Users are connecting to an aplication via web browsers, some tags on the web page are available under VIP/port1, othe...

Hi Guys,Looking through the release notes for A5(2.1) I noticed that there are a number of open caveats which indicate that the bug has been fixed in a version that is not available as yet on CCO.  Example:•CSCuc04894—The ACE reloads without generati...

Ok, here the problem I´m having:Nexus 7000 (nx-os 5.2) connected to my WAEs and configured for only one of the VRFs.I want to add another one from the VRFs already configured on the Nexus to the WAAS (4.3). Is this possible? Does anyone have some exp...

Dear Gents,Attached is the current setup & configuration for both ACE & FWSM.we can ping the VIP from the user side, but we are not able to open the web application using the VIP.Appreciate your kind support to solve the issue when trying to open the...

Hi,When connecting to an IBM Websphere thru the ACE, the user gets a return URL with a port number which blocks communications since only port 80 is permitted.Ex: user goes to http://maximo.abc.comThe browser gets back the following url http://maximo...

Hi All,I'm working on a specific config and have an issue in the backup farm/fail-over/sorry server area.The customer wants the following:They have an existing serverfarm with X web servers, they want a single server to act as a reverse-proxy in fron...