APIC Boot Failure...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-04-2025 11:51 PM
Recently, while downgrading the APIC, the equipment seemed to freeze, so I performed a reboot. However, the boot process does not proceed beyond the screen shown in the attachment.
The same issue occurs when attempting to boot using USB, vCIMC DVD, or vKVM DVD - the boot process halts at the same screen in all cases.
If anyone has experienced this issue and successfully resolved it, please kindly provide me with the solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-05-2025 01:02 AM
Hello @Translator
The screenshot you shared, showing ISOLINUX 4.05
, indicates that the system is attempting to boot using the ISOLINUX bootloader but is unable to proceed further. This issue often occurs when the boot media is corrupted, improperly prepared, or incompatible with the hardware or firmware version.
HTH
AshSE
