Hello,I'm trying to setup a pretty simple solution for web servers load balancing using ITD on Nexus 93108TC-EX with NX-OS 10.3(6)M.There is a Deployment guide for Direct Server Response (ITD Service), and I'm following it with 3 exceptions:Ingress ...
I had a really old DNA sitting on a shelf since before COVID that i just plugged in.I got the CIMC setup and i ran the Maglev Wizard and i do believe it completed (finished after work hours).If i log into the CIMC and Launch the KVM is get a "Welcome...
Good day,I am planning to get rid of the N5K Datacenter Fabricpath to be replaced with Nexus 9K.of course, VPC will be in place for the N9K but what will be the best replacement for the Fabricpath replacement.1- Migrating Cisco FabricPath Environment...
Good afternoon,We need HTS, Harmonization Code and ECCN for the following item.Cisco Catalyst 3560-CX 12 Port
Consider that L3Out Link is not yet in Place between PRD Tnt to ISN RTR ( at left side of the Diagram ). I am evaluating the situation if I bring the L3Out Link between DR PRD Tenant to ISN RTR. At DR Site PRD Tnt through L3Out it will receive Route ...
Hello WAAS Experts,Can Cisco WAAS communicate with Juniper WAN Optimizer? If so, which Cisco and Juniper hardware models?Thank You,Audie
I'm looking for the HTS and ECCN for an XRV-M7-APLN-100G.
Recently, while downgrading the APIC, the equipment seemed to freeze, so I performed a reboot. However, the boot process does not proceed beyond the screen shown in the attachment. The same issue occurs when attempting to boot using USB, vCIMC DVD, o...
Hi Team, It is possible to use Cisco SNS-3715-K9 (ISE) and SNS-3615-K9 (ISE) together in a high availability (HA) configuration. Regards, Anand Gupta
Dear all,may I ask you a support for missing HTS code for the following item?Part number: SMC AMC520-N04BDescription: EXHAUST CLEANER INSURE CLEAN PLANT AIR AND REDUCE NOISE POLLUTION OVER 35DBThanks in advance.Best regards,Paul
I'm trying to run a tcl script (via automation or pasting into vty. The commands all individually work but if I try to push it all out, it stops feeding the commands after the first "if" conditional command.I'm basically trying to rewrite a couple o...
Hello, can you help for a HS code for: CISCO_MX68-HW End delivery will be Paris, France. Kind regards, Rob.
When attempting to run various show commands on APIC ACI, no output is generated, and the commands are not working as expected. Could you please assist me in identifying the cause of this issue?
Buenas tardes, Se intenta agregar un fiab en dnac, solo queda por ultimo cargar el wlc pero da el siguiente error. Alguien sabe como poder solucionarlo sin borrar del fabric el sw 9300 Gracias de antemano. Ciro G. Mele
