Application Networking

What if, I wanted to use TWO wan optimizing pieces of hardware--One WAAS and one another vendor? Both "Head-End" devices would need to use a WCCP redirect off the same GIG and POS interace (with a different ACL and WCCP number) BUTTTT..the problem it...

I have noticed that our Directory Services traffic (LDAP) is showing an increase rather than a reduction. I've run into similar issues with Citrix and know that is due to Citrix native compression and encryption and deal with that by altering the pol...

Hello,I'm testing an ACE module in a 6509 chassis. I am using ACE firmware c6ace-t1k9-mz.A2_2_0.bin. I use a script which replaces the variables of the following config with something unique to insert vips.Config:class-map match-all TEST_CLASS_%NUMBE...

HiI have two separate Unix servers behind a CSS running v8.1. They are accessed via Content/Service rules from client workstations with a one to one mapping between the Content Rules/Services. When we SSH to one server the SSH connection never times ...

What is the core fan out ratio for the WAVE-274? Can you explain how Cisco is determining the core fan out ratios and how they size a WAE for a particular environment based on DRE size? Its my understanding that the DRE cache values in the DRE databa...

Hi,I have an http session between Web Server farm and Application Server Farm.After firt http request, Application Server send this pck (see file http_header.txt ).So, I configured http cookie Stickiness with Dynamic cookie learning:sticky http-cooki...

Hi,While deploying WAAS,i ran into some problem with one of the edge WAE,it has constantly shown its CMS status as offline.The problem is it comes online then goes offline almost immediately.Whats more is that i can't telnet (I can ping it though)to ...

VIP : 10.10.10.10:8000rserver server1ip address 10.10.10.1serverfarm SFARM1rserver server1 8001 probe Probe_8001rserver server2 8002 probe Probe_8002rserver server3 8003 probe Probe_8003rserver server4 8004 probe Probe_8004I would like to loadbalance...

We have a server behind a ace loadbalancer doing sftp and we see constant messages on the server as follows:Apr 13 10:01:12 nj09mhf5006 sshd[25155]: [ID 800047 local7.error] error: setsockopt SO_KEEPALIVE: Invalid argumentApr 13 10:01:13 nj09mhf5006 ...

We are in process of deploying MS Exchange 2k7. I would like to configure the ACE 4710 to load balance the client access servers. These servers will use port 80 and 443. What is the best practice? 1. Should the ACE pass 443 traffic through?2. Should ...

Hello, is it possible to achieve site to site redundancy using the ACE appliance but no GSSs? If so, is there a preferred method?ThanksRae

We would like to configure on ace like below:the virtual ip address and port like this: 10.10.10.10:8000,this ip address will be use to outside user request servie and we have to configure server farm like belowreal server 10.10.10.1:8001, 10.10.10...

I plan to load balance user traffic to a server farm. Currently, server is using cookie to generate delay/response time statistic for users from various locations. If I use ACE to load balance user traffic, I need to use NAT statement on ACE to mak...

Hi Guys,I have a WAAS device placed between two routers and two switches. One switch and router group autonegotiates perfectly fine 100mbps full duplex. The other router and switch group however does not. The switch port is gigabit and the router por...