Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I think I kinow the answer to this question but can anyone state confidently if NCS can be monitored/managed by WCS Navigator?It doesnt appear so according to the compatibility matrix...http://www.cisco.com/en/US/docs/wireless/controller/5500/tech_no...
Is it possible to run a report containing all Disassociated APs? I tried all the Device reports in the report launch pad and they only report on associated APs. I can obviosly view them in Monitor/Access Points but I cannot report on them. Any help w...
When I reposition an AP on a map, I get a message..Saving these settings might cause the radios to reset if the antenna gain setting on the WCS is different from the setting on the controller. Is this true? I do not plan on adjusting the antenna sett...
I am attempting to configure a discovery filter to exclude my Access Points. The filter looks correct and I finish the configuration. When I run the discovery it stills discovers the Access Points! How can I get the filter to work properly?I have att...
I have deployed Multicast in my environment and am trying to make sure everything is working correctly at the L2 user access switch. User can receive the mCast stream with no problem but I want to make sure that connected ports that are not participa...
Hi Aaron, Very nice to see code recommendations straight from the team that deals with the flux of issues. You are always a trusted source. Thank you! Would you happen to know if and when the MIC Expiration 'Bug' CSCuq19142 will be resolved in the 8....
Thanks Ram,Makes sense. What Gain are they refering to specifically? The one determined by Antenna Type or the Gain as defined by the Power Level setting?Thanks,Phil
I set up one of the APs as the Seed Device with a Hop Count of 1. This allows me to make changes and quickly test the discovery.The AP IP address is 10.104.20.80 - You will see this near the end of the log and is the only device that is discovered. ...
