Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 4 GSSs in the network, the standby and regular gss devices have status of either Online or Offline for all the answers when checking the Answer Status under the Monitoring tab. However, the GSSM states Unknown for a few of the answers (most ha...
Hello,Is it possible for me to install a CA root certificate, provided by Linksys so that linksys devices, which have client-certificates built-in, can authenticate against that CA root? This way, only devices will be able to access the protected con...
Can anyone give me assitance in browsing to the dynamic share on the file servers? I am trying to browse to the UNC path of the server \\waascore\test and I am getting just an authentication box but never goes into the actual share. When I go to the ...
Hello there,I have newly integrated a GSR 12012 as a BGP Peer. We want to implement WCCP for web caching. Configured ip wccp web-cache and ip wccp web-cache redirect out (Internet interface)ip wccp web-cache redirect in (Internal interface)ip wccp re...
Dear Sir,I have a pair of 11501 and need to load balance a pair of web/mail servers. Below is the reloated configuration on one 11501.interface e3 bridge vlan 30interface e8 isc-port-one!************************** CIRCUIT **************************ci...
I have a Standby CM running 4.0.9 that we just installed. Tried to upgrade it to 4.0.19 and it just sat there in pending state for a long time. It appeared to be hung because I couldn't get to it remotely any longer. Rebooted the box and set it up as...
The heading marked (2) as I found a similar question before.When trying to add resource to another context, error occures.details:resource-class 001_Res limit-resource all minimum 0.00 maximum unlimited limit-resource sticky minimum 30.00 maximum...
Hi,I've a problem with license install procedure on ACE. If I try to perform cisco procedure:LICENSE KEY INSTALLATION INSTRUCTIONSAfter you have received the software license key for a new or upgraded license in an e-mail from Cisco Systems, you must...
Hello,we have Problems to work with WAAS (4.0.17b14) in conjunction with ASA (8.03) and VPN-Router (12.4(15)T5).The flow is:Cat6509 (122-18.SXF14) with wccp v2 configured and GRE-redirect - one arm- -> ASA (8.03) with inspect waas -> L2l-Tunnel -> CS...
Hi I'm affected by bug # CSCsm17268Anyone know anything new about this problem, I now have only one ACE context active and the other is in STANBY_COLD."In a redundant configuration, when you add a single line to an existing config (for example, Admin...
I have downloaded the latest version of waas software to both the primary and stabdby CM. I now need to reboot both to have the changes implemented. Please tell me the exact steps to follow(which one to reboot first?). And any precautions to be taken...
