Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to check the virtual-address using show command.however, there are not in ACE. So I used the ping to check virtual-address status in ACEI want to know the command what is verify virtual-address status , using show commandThank
I terminate http and https on the ACE. Within the L4 multi-match policy exists a class for inspection purpose.The class itself filters onport misuse p2pport misuse import misuse tunnelThe action for a valid match is reset.Somehow WebDAV traffic gets ...
I have a question about the capture command.I would like to capture the traffic through ACE. So I tried the capture traffic like below#capture aaa all, but error.the error message is 'the buffer not set'the error message is not extractly but the same...
Folks, I am trying to configure ACE in transparent mode and it is not working, i can browse to the servers directly,but when i try to hit the vip , I do not get any webpages, all keepalives are up and everything is in inservice.hostname abcboot syste...
I am considering buying the ACE 4710 for SSL termination and server load balancing. But I also use the Akamai service that also "plays" with the SSL session. Has anyone implemented an ACE with Akamaized https content?
Is there any performance issues with redirecting wccp 62 on an SVI of the 6500 series switch? The WAN interfaces are not layer 3 but are associated with a vlan that has an SVI configured. I will be using redirect lists for interception.Regards,
As previously mentioned, I have a 612 as the Center Manager and two 7341's, one in the datacenter and one at a remote location.With the two 7341's registered to the CM, using either the CM GUI or CLI on each 7341, I am attempting to enable disk encry...
Hello, I currently I have a CSS11506 configured for reverse proxy mode. It terminates all inbound SSL connections via one VIP. The backend connections to the web servers are port 80.Is there a way for me to configure 6 urls to one public VIP and then...
I currently have a CSS that terminates the inbound SSL connection. It then makes the backend HTTP connection to the webserver. My problem is the first time I surf the HTTPS url the page loads perfectly, but if I refresh the page or try and start up a...
The problem is the oracle application uses multiple ports as there are a number of different components that the application calls. The ports are 8001 and 9001. However, content rule can only have 1 port number specified.The oracle application works ...
Hi,In the CSM it's possible to insert an HTTP header that contance the original Source adress before NAT.Is there such a feature for the CSS as well?Cheers,Gerrit
I need to upgrade my csm card from sw 3.1(4) to sw 4.1(6).Is there any issue when upgrading such version on a hw 1.8?Assuming that I might install a second CSM card in failover mode, and assuming that this card is hw 1.9 and sw 4.1(6), is there any i...
Can the natpool IP addresses be the same for both the CSM and SSL module. Additional information....we are load balancing across two SSL modules and CSM's are in active/passive mode in two seperate Catalyst 6509's. There is 8GB Etherchannel connectin...
hi.My customer been used used the alteon L4at these day, We changed from alteon to ACE, the conversion was successful, but there are some problem in roundrobin loadbalancingfor example, we tried LB test only one host, the host are trying to connect v...
