Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are seeing input-drops on one specific sub-interface of a Bundle-Ether: Bundle-Ether2.333 is up, line protocol is up Interface state transitions: 11 Hardware is VLAN sub-interface(s), address is 5087.896d.e392 Internet address is xx.xx.88.94/30...
Ever since we switched to ASR1004 running XE15.1(2)S1, we have seen that the output of "show ip cache flow" stallsand is super slow to complete. We have a few interfaces with "ip flow ingress" defined. What can be causing thisslowness? Any recommen...
In all the IOS versions I know of, when doing a show conf I would see something like this:interface GigabitEthernet9/1 ip address 12.13.22.129 255.255.255.0Recently I think I saw a sho conf that showed it as:interface GigabitEthernet9/1 ip address 12...
Is there some site that lists all the possible "Platform" responses to a "sho cdp nei"?Examples would be:WS-C2950GCISCO761318417206VXRC831etc.But I would like to see a comprehsive list of what Cisco can return as a response.Thanks!
We have a 7613 w/ WS-SUP720-3BXL running 12.2(18)SXF11. We have a48 port WS-X6748-GE-TX that has one interface that keeps getting outputdrops for anything over 200Mb/sec.See the attached file which has more details and show results. I would have pa...
Still unsure which NP:RP/0/RSP0/CPU0:GP1#sho cef tunnel-ip5 location 0/0/cpu0Thu Mar 5 10:14:05.961 ISTPrefix Next Hop Interface------------------- ------------------- ------------------100.99.141.198/31 attached tunnel-ip5100.99.141.199/32 receive t...
Thanks. I now see:RP/0/RSP0/CPU0:GP1(config)#hw-module location 0/0/cpu0 tcp-mss-adjust np ?<0-7> Number between 0-7But how do I find where the tunnel interface is located among the various NPs?
Running Cisco IOS XR Software, Version 24.4.2 on AS9906. Command doesn't work with "location" parm:RP/0/RSP0/CPU0:GP1#hw-module ? satellite Specify which satellite(s)subslot Execute subslot h/w module operationsNeed to set MSS on tunnel interface. ...
Using S/RTBH on an ASR9000, can it work if I am not interested in sending the data to null-route but rather to a pkt scrubber (set next−hop 1.1.1.1) for processing and reinsertion back into the network? Does uRPF make a difference in this case if I ...
