Application Networking

We have 2 CSS11503, one as Master and other as Backup. We've had problems because one service has been down and only after reboot both devices we have recovered the service.Any idea how to identify cause of this problem ?Today we had same problem and...

Hello, I have a Content engine, which uses the ICAP to evaluate the virus of the web pages or files. But since i have put this protocol the system isn´t caching and if i remove this protocol the system caches. What is the Problem? The antivirus is Tr...

How can I balancing an UDP Flow on per packet bases without stikyness?I know that it is possible with CSS using "flow-state" command.Gilberto.

Css11800 running ap0610405 (6.10 Build 405). Try to setup default routing with NAT as suggested on theforum "default routing depending on source-address" dated 08/11/04. CSS connects to two firewall interfaces - 10.1.1.1 and 10.1.2.1 (vlan 10 and 20 ...

We have a Cisco 11503 running 7.40.1.03 (standard feature set) that we are setting up as a load balancer for a new e-mail system. I had two previous threads - thanks to Gilles and the others who responded. The box is now more or less configured to do...

Are there any known issues relating to using self signed certificates to the backend?We are unable to negotiate a successful SSL session via the web through the CSS to backend servers.Software version is sg07.30.3.13s

Anyone have experience front-ending a JBOSS application with an 11500? Any weird ports or unusual behavior to be concerned with?

Can someone tell me the difference in operation of this sticky rule: "sticky 5 netmask 255.255.255.255 timeout 60" vs. "sticky 4 netmask 255.255.255.255 address source/destination timeout 60"? What is the first rule actually sticking on?Thanks,LB

Having X physical servers each having Y logical services/IPs, is it possible to implement bandwidth management/QoS on the CSS? I.e. requests to service Y1 must not exceed a certain bandwidth on the backend link of the CSS?Thanks

Hi.How to bypass some source address in Transparent Caching with CSM ?If configuring bridge mode or routed mod in Transparent Caching, need some source IP bypassing and the other source IP caching.Is it possible? if possible, let me know how to confi...

Hi,I have a LD 417 to forward packets to 2 servers (A&B running redhat cluster suite). The IP address of server A and B are 10.10.10.1 and 10.10.10.2 respectively. The virtual ip for server A and B is 10.10.10.3. Since the 2 servers are clusters, onl...

tried configure simple http pool for load balance as following, please advice me what I did wrong?circuit vlan10 ip address 10.1.1.1 255.255.255.0service http ip address 10.1.1.2 range 10 protocol tcp port 80 activeowner WEB content HTTP vip address ...

hi.I found How to Configure Transparent caching on Cat 6500 with CSM in routed mode.But,I need help How to Configure Transparent caching on Cat 6500 with CSM in bridge mode?Please let me know sample configuration.thanks.