Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I want to setup a PIX 520 in a lab environment and since that PIX have been sitting on the shelf for a while nobody knows the enable password. I tried using the recovery has mention at : http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/pro...
Hi All,This one is really odd and I'm not even sure it has to do with the switch itself.One of my server is on VLAN 10, when I try to ping any devices it ends up that I get really high latency from two VLAN out of five. Here's the ping output from th...
Clients are able to connect with a unique un-broadcasted SSID and WEP128 enabled but are unable to get their DHCP requests from the DHCP server behind the AP. When WEP is turned off, DHCP relay works and assigns an IP to the device. So it looks like ...
We have a CSM in 6500, and the way the application works on the reals, when the client innitiate a request it then start a new connexion to the client. That connexion gets innitiated from the real directly to the client. I'm trying to find a way to g...
We got a small server farm with four real servers and one vserver. when the client initiate a connection with the vserv it opens up an RPC at a certain point and starts talking directly with one ofthe real servers totally bypassing the vserver and if...
There are no hign latency from workstations using ping or traceroute on these two VLANs but telnet takes forever and once the users login the application runs fine.The traceroute I was talking about were initiated from the two servers.Here's an examp...
Rick,It is consistent with the same two vlans, all the others are okay. Tomorrow morning I'll try puting a sniffer on a span port to try to make some sense out of all this. By the way the only other interesting thing that I found and it could well po...
The inter-VLAN routing is taking place on a 6509 which is our core switch and where the server is connected to as well.That switch is the root switch.Thanks for the pointers, I'll keep on investigating.
Gilles,We did get a lot of hit on the new vserver and I also saw a lot of connections, but most of them were going to some Sequal server and the clients wern't able to connect to the application.I'll send you the commands outpus and a copy of the con...
