Application Networking

hello, I've setup a CSS115001 for load balancing two web servers. I am using just the basic L3 rule for load balancing and noticed that every so often I get this error:-"MAR 17 10:00:56 1/1 29 IPV4-4: Duplicate IP address detected for vip: 65.214.xx....

I've seen a lot of documentation about redirects and what I am trying to do seems simple enough yet I can't get it to work. Here is a summary:We have two CSSs in different data centers with load balancing in a roundrobin fashion.User types www.test.c...

Hi I am trying to use a cisco cache engine module in a 2611 with wccp and client IP spoofing enabled. Everything seems to work fine apart from 1. Proxy protocol redirected packets always appear to be coming from the cache engine rather than from the ...

I have been researching PIX stateful failover in conjunction with CSM (6509 blades) and determined that the failover PIX bundle is needed in between the content switch sandwich. I read in "CSM Module Installation and Configuration Notes" for 3.2, tha...

We need to migrate from an existing one-armed NON-Transparent Proxy Deployment to one of the following designs in an effort to give us transparency at the server level ( ie see the client ip addresses )The Choices seem to be as follows : One-Armed Tr...

Hi,scenario with two CSS and two SCA for SSL offload from Web Servers as described in the SCA Config Guide (deployment examples one-armed (non-)transparenton proxy) on CCO.The example configs are definitly not correct - VIPs or static-route-next-hops...

I have Local Director 417 with 4.2.5. It has several virtual machines configured on it. Each machine is bound to group of real machines. However real machines for some of virtual groups are hosted on same group of boxes (on different ports of course)...

Does anyone know if CSS ACL's are stateful connections once a flow has been created ? eg If i make a connection which looks at the acl clause and i am permitted (which creates a flow) are subsequent packets checked at acl's or does it use the flow th...

I am load balancing multiple ISA servers with a pair of 11506's - with Exchnage 2003 running behind them.I am not to fimilar with Exchange 2003 so I am not really sure how to customize a script that will validate whether the mailbox services are runn...

I've run into an issue with a new scripted keepalive. I've created the script and copied it to a CSS11000. I can run the script manually and it works as expected, however when I add it to a service, it is not run. After the service is activated, the ...

i had a requirement of having a Primary and Backup server scenario, i.e users will only be directed to the backup server if the primary is down.It did failover (by suspending the primary server). But when I bring up the primary server, it still point...

Could I have some advice on1/ How to work with serial IP address for software upload2/ How to TFTP or FTP s/w to the Content Accelerator. (I tried using IP address for PC ethernet and Accelerator Serial (Console?), within the same sbnet. Can not ping...

I just purchased a 510 Content Engine for my customer.I went thru the initial setup dialog, and have the base config on the box. The instructions on the web indicated that once configured, the CE would tell me what port to use in my browser to get to...

When using SSL modules in the CSS, does the client source IP address show up on the web server? Or does the CSS do a source NAT so the packet comes back to the SSL module?

Hello,I'm searching for a possibility to adjust the timer when a TCP-session is declared to be down. The config is quite easy a VIP pointing to several services. I found a solution by using add destination service... but I do not have the possibility...