cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
3149
Views
5
Helpful
1
Replies

boot error

johng231
Level 3
Level 3

Getting the following boot error at one of our remote branches. Anyone seen this error before? I had them powered it off and on and still getting the error.

WAE-674

4.2.1

Broadcom NetXtreme II Ethernet Boot Agent v2.8.5
Copyright (C) 2000-2006 BroadcomCorporation.
All rights reserved.

Adaptec RAID BIOS V5.2-0[Build 15418]
(c) 1998-2007 Adaptec, Inc. All rights reserved.

<<< Press <Ctrl><A> for IBM ServeRAID Configuration Utility! >>>

Booting the Controller Kernel......Controller started

Controller #00: IBM ServedRAID 8k at PCI Slot:00, Bus:04, Dev:00, Func:00
Waiting for Controller to Start....Controller started
Controller monitor V5.2-0[15418], Controller kernel V5.2-0[15418]
Controller POST operation successful
Controller memory size: 256 MB
Controller WWN: 5005076B04078A45
!!!CRITICAL ERROR: Memory retention failure, unflushed cache lost!!!

Configuration Utility
Press <Ctrl-H> to Pause Configuration Messages
(Default is to Cancel all imports if no valid key pressed in 30 seconds)

1 Accepted Solution

Accepted Solutions

fbergamo
Cisco Employee
Cisco Employee

Hi,

Apparently this is the known issue documented on CSCsv56894

Regards,

Fabio Bergamo

Cisco TAC

View solution in original post

1 Reply 1

fbergamo
Cisco Employee
Cisco Employee

Hi,

Apparently this is the known issue documented on CSCsv56894

Regards,

Fabio Bergamo

Cisco TAC

Review Cisco Networking for a $25 gift card