can't exec configsync command

[thitonus1555]

Hi, Please tell me.

■back ground

・I have two Load Balancer in my office.

The both two are CSS11506.

Version: sg0740202 (07.40.2.02)

It is cluster configuration.

・When I change the config file

1: change the config file of one Load Balancer (test02)

2: try configsync

・up to now,I succeeded to do configsync by this way.

This time, however, I failed.

■actual state

・When I tryed configsync , following message was displayed.

??????????????????..

test02# configsync

test02#

Checking available disk space on systems ...

Verifying app and redundancy configs ... \

Previous synchronization still occurring on remote switch.

????????????????????..

・When I performed next command ,following[TAB] was displayed.

・test02#show script + [TAB]

[TAB]

(?some choices)

vipr_sync_running

・test01#show script +[TAB]

[TAB]

(?some choices)

bckupinterface

bckupcircuit

remotecmdsched

remotereportercfg

newconfig

vipr_redund_sync

commit_vipr_log

commit_failure

viprconfigsyncdone

■wish

・Next time, I wanna succeed to do configsync .

What should I do ?

Please tell me.

■My speculation

・I may have to do following command.

Is my speculation collect?

test01#clear script bckupinterface

test01#clear script bckupcircuit

test01#clear script remotecmdsched

test01#clear script remotereportercfg

test01#clear script newconfig

test01#clear script vipr_redund_sync

test01#clear script commit_vipr_log

test01#clear script commit_failure

test01#clear script viprconfigsyncdone

test02#clear script vipr_sync_running

[mrembetsy]

had this problem with my 11503's

it was with commit_Vipredund.."local x.x.x.x remote x.x.x.x -f"

the -f removed the locked temp file and fixed the problem..give it a try with "-f"

[thitonus1555]

thank you mrembetsy.

[present conditions]

Now,a Load Barancer(test01) is active and the other one(test02) is standby.

when I perform on the active Load Barancer(test01),I should try with "-f".

But,I don't wanna stop active Load Barancer(test01).

[My wish ]

I wanna execute configsync on the standby Load Barancer(test02),

When the Load Barancer(test01) is active.

What should I try on standby Load Barancer(test02).

thank you mrembetsy.

[present conditions]

Now,a Load Barancer(test01) is active and the other one(test02) is standby.

when I perform on the active Load Barancer(test01),I should try with "-f".

But,I don't wanna stop active Load Barancer(test01).

[My wish ]

I wanna execute configsync on the standby Load Barancer(test02),

When the Load Barancer(test01) is active.

What should I try on standby Load Barancer(test02).

[Gilles Dufour]

you should not execute the config sync command on the standby.

Only on the active unit.

The -f option just means FORCE config synch.

You have to execute the command on the active unit.

It should not impact the traffic.

Gilles.