07-05-2010 12:09 AM
Hi,
While deploying Cisco waas in inline mode with allot,I am facing interface issues.
Set up is like router-->cisco waas-->allot-->l2 switch.
Can you pleas hep.
Regards
Ravi
07-05-2010 01:55 AM
Hi Ravi,
I've had interface issues with inline cards whenever there's a speed difference, ie. 100m vs 1gb, etc, with the LAN/WAN endpoints. I'm not sure what type of interfaces your Netenforcer uses, but the following link may be helpful.
You may need a crossover cable somewhere inline.
Hope this helps.
07-19-2011 10:25 PM
Hi dear,
I will apreciate that you send the LINK again , becouse when I try to opened the link not reponse.
I have a same case the Ravi.
SW --> WAAS --> ALLOT --> ROUTER.
I need information about the issue when in the implementation is the ALLOT with the WAE.
07-19-2011 10:44 PM
Hi,
Yes there is challenge in placing the WAAS device in inline mode and its is not with waas but with any wan optimization device.
Best way is to use WCCCP mode and redirect some specific traffic . If everything goes well, you can redirect the complete subnet using WCCP mode.
Regards,
Ravi Kumar
Technical Specialist- ITS
GSM:+91-9810908415
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide