07-25-2016 01:03 AM
I have new Cisco ONE ISR 4451 that comes with ISR-WAAS. I need to migrate from Cisco WAE (inline) to Cisco ISR 4451 (in-path)
Is it possible to configure Cisco ISR as in-path and how what is the best practice to migrate from WAE CM to Cisco ISR 4451 (ISR-WAAS)?
07-29-2016 05:26 AM
Hi Darren,
It dependends what you mean by "inline" ?
You'll need to route traffic through the router (from one interface to another), but Layer 3 routing is required.
And then do redirection - either AppNav (on one interface) or WCCP (on the two interfaces) in order to redirect traffic across the ISR-WAAS (which runs in a container on the ISR-4451).
So you could state that the router is in-path (or a bump-on-the-wire), but not really inline (the old inline deployment was a "Layer2 bridge" like solution).
Best regards
Finn
08-23-2016 03:54 AM
Hi Again,
Apparently Cisco has changed something, so WCCP is not supported on ISR-WAAS.
See bug-id : CSCva69516
Sorry
Finn
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide