CSM concurrent bridge and router mode

[m.baker]

Hi,

Is it possible on the CSM to use bridge and router mode at the same time ? Or is it only router mode or only bridge mode ?

E.g. in the example below, when using HTTPS entering the vlan 3 , it will be bridged to vlan 3....But when using HTTP entering vlan 3...it will be routed to vlan 4... Will that work ?

Thanks

vlan 3 client

ip address 3.3.3.1 255.255.255.0

vlan 3 server

ip address 3.3.3.1 255.255.255.0

vlan 4 server

ip address 4.4.4.1 255.255.255.0

vserver HTTPS

vlan 3

virtual 3.3.3.10 tcp https

serverfarm HTTPS

!

serverfarm HTTPS

no nat server

no nat client

real 3.3.3.11

inservice

real 3.3.3.12

inservice

vserver HTTP

vlan 3

virtual 3.3.3.11 tcp http

serverfarm HTTP

!

serverfarm HTTP

nat server

no nat client

real 4.4.4.10

inservice

real 4.4.4.11

inservice

[jfoerster]

HI Michel,

first of all you can run bridged and routed mode at the same time but you can not define the same vlan as client and server. If you would change the above config from vlan 3 server to vlan 30 server and place the reals in vlan 30 it will work. A proper layer 2 configuration is for sure the prerequisit.

Kind regards,

Joerg