Application Networking

CSM 4.1(2). I have application which use sticky. To take a real server to go gracefully down, the manual tells me to set the server in inserve standby, so all connections and sticky database can timeout. When I try to do that, there is no parameter "...

Hi,Is there a way with the CSS11501 to create the equivalent of a policy route ? E,g, If packets destination port is TCP 25 or UDP 23 and the packets are from VLAN x then forward the packets to address Y ? Can this be done with content rules and serv...

Does this trap only work for service transition of Active-Down and vice versa?apSvcTransitionTrap TRAP-TYPE ENTERPRISE svcExt VARIABLES { apSvcTrapEventText } DESCRIPTION "A service transition trap is generated whenever the the service state transiti...

Does anyone have an example of using the CSS 115000 to load balance outlook web access across a few servers? I have no idea were to begin. Thanks in advance

I am using a csm on a 6500 in Native mode and trying to get an SSL module up and running. I have done the initial configuration as shown in the docs, setting up a VLAN 2 on the MSFC and on the SSL module as admin, gateway is the ip address on the vla...

Hi all,Anybody know the oid to save configuration with SNMP ?Thanks

Hello:I'm trying to track activity on a CSS11800 and have been watching TCP Connections with "sh serv summary" and TCP Flows with "sh flows 0.0.0.0". However, there doesn't appear to be any obvious correlation btw these figures.Can anyone tell me whi...

Is there any way to keep a source group from remapping TCP source ports?

I am configuring a 11503 for load balancing. I have the following configservice iowa1 ip address x.x.x.x keepalive frequency 10 keepalive type http port 80 activeThe http keepalive is not working. However, if I change the keepalive type to icmp it wo...

If two CSS's have been configured as active and standby (VIP redundancy), and one of the interfaces of the active CSS goes down, and say the backup becomes active, I lose total connectivity to the Active box via the management interface IP. Once it r...

Anyone know of a way to configure the CSSs to handle dynamic server written cookies? Basically I have two DMZs which are each load balanced with a pair of CSSs. When using arrowpoint cookies on both pairs to keep session, I think one is overwriting t...

Hello,We need to create some statistics on usage of a couple of websites. The tools used to produce this are based on the traffic logs. Whenn we use the server logs we see only 1 client, the Content Switch...I like to know whether it is possible to g...

If a firewall is located between a CDM and a root CE, what ports need to be openned for the CE to communicate with the CDM? Does Cisco have a white paper on port usage in a CDN environment?Thanks,Randy

Hello, I have setup our GSS sending http-keepalive to 2 web server for failover method. When I check on the GSS answer status, it appears that one of the web server is offline. But when I suspend the answer and bring it back up. My GSS can see the an...